Falmec FFALT24W5FS Manuel d'instructions télécharger pdf (Page 23)

are completely dry before repositioning them. To remove and replace these filters, see

the instructions in point H1. This operation should be performed at regular intervals.

2. CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is purified

by passing a number of times through the filters and being recirculated into the kitchen. The

charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months (ac-

cording to use). To replace the charcoal filters, see the instructions in point H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid

that oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid

detergent or denatured alcohol.

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using

clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain

abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using

abrasive substances or rough cloths will inevitably damage the finish of steel. The steel

surface will be irrevocably damaged if the instructions above are not complied with. Keep

these instructions together with the instructions for use of your hood.

The manufacturer accepts no liability for any damage caused by non-compliance with the

instructions above.

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be

cleaned using liquids or solvents.

Do not use abrasive products.

All the above operations must be performed after having disconnected the appliance from the

mains power supply.

WARRANTY

The new equipment is covered by warranty.

The warranty conditions are provided by the distributor.

The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or

transcription errors. The manufacturer reserves the right to modify its products as it consid-

ers necessary or in the interests of the user, without compromising their essential safety and

operating characteristics.

HOODS MOUNTING INSTRUCTIONS

WARNING: Failure to install the screws or fixing device in accordance with these instructions

may result in electrical hazards.

ALTAIR WALL HOOD ASSEMBLY

Phase 1

- Place on the wall support bar (A) (Fig. 1), at the same height of the cooker resulting from the

sum of the heights X + 260 mm.

- With a spirit level, verify the horizontal alignment and mark two drilling points at the edges of

bar n. 2.

- Drill, insert n. 2 expansion bolts of 8 mm Ø and fasten the bar with the relative screws.

English

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

Falmec FFALT24W5FS Manuel d'instructions Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Falmec FFALT24W5FS